 |
1.
Set the appliance on the floor and remove the water bottle.
Place the steamer hose with the nozzle head up on the
hanger rod. Make sure the hose is free of kinks. |
 |
2.
Fill the water bottle with cool tap water. Invert water
bottle into the reservoir. Turn switch to ON position,
the power indicator shines when the unit is ready to
release steam within a minute. During operation - check
the water level |
 |
and do
not allow it to run dry. The steamer will operate properly
for longer if you do not allow the water to be completely
drained during operation. NEVER fill the water bottle
with hot water. |
 |
 |
3.
Grasp the control handle of the steamer
hose once the steam is being released. Hold the control
handle with the nozzle facing upward and begin at the
bottom of a garment allowing the escaping steam to rise
inside and outside removing the wrinkles as it rises.
|
 |
4.
Cleaning and storing the steamer. Turn the switch to
OFF position and wait for the steamer to cool down before
draining. Lift the base over a sink and empty the remaining
water in the reservoir, this will help to dislodge any
sediment that has accumulated. While you do not have
to empty the water bottle each day, you should
periodically |
 |
empty the old water out of the steamer and remove
any sediment that may accumulate.
| Other
Important Notes During Operation |
 |
If the steamer hose gurgles
during use:- |
| |
This is a
normal condensation taking place inside the
hose. Simply lift the control handle upward
until the hose is extended to its full height.
The gurgling will disappear when the excess
moisture inside the hose has drained back into
the base. |
| |
|
|
 |
|
If the steamer stops producing
steam then starts again:- |
| |
This may be
due to the accumulation of sediment from the mineral
laden water at the reservoir. Please consult the
Service Centre. |
| |
|
|
If the steamer indicator
light does not turn ON and the unit does not produce
steam:- |
| |
There may be
an electrical problem with the appliance. Disconnect
the power supply immediately. DO NOT use the unit
until you consult our qualified technician at
our Service Centre. |
| |
|
|
